Mace MAS-WA-SYS Podręcznik Użytkownika Pobierz pdf (Strona 12)

e. arminG the SyStem

On the Keychain Remote Control: Press to ARM the system.

On the Wireless Alarm Panel: First make sure the panel is in STANDBY mode, and then ARM the

system by taking the following steps:

Keys Description Note

(1234 or 4-digit

PIN) +

You must be in STANDBY

mode before turning to

ARM mode

*To make sure you are in STANDBY mode:

- Enter the default PIN “ 1–2–3–4 ” OR your new 4-digit PIN

- Press

- The panel will display the below image while you are in

STANDBY mode:

(One beep indicates that you entered a valid PIN, three beeps

indicate that an invalid operation was performed).

(1234 or 4-digit

PIN) +

Enter 4-digit PIN, press

and

for ARM mode

Exit delay: Up to 15 seconds

– There is a 15 second exit delay time with a visual and audible

(beeping) countdown before the system is armed.

(Press MUTE to disable the beeping countdown, press

MUTE again to resume the beeping)

– If the Zone is enabled, a number will appear as displayed in

the image below:

- The system will then enter ARM mode after 15 seconds.

When in ARM mode, the Wireless Alarm Panel ﬂashes RED every 5 seconds, acting as a deterrent to

potential intruders. However, if an intruder is detected the panel continuously and rapidly ﬂashes RED.

Once an intrusion has occurred (with the zone triggered under ARM status), the alarm siren will

sound and the panel ﬂashes RED every 1.5 seconds with the triggered zone indicated. After the initial

triggering, the alarm will immediately sound, without delay, if any other sensors are triggered.

f. diSarminG the SyStem

• On the Wireless Alarm Panel: Enter your 4-digit PIN followed by to disarm the system.

• On the Keychain Remote Control: Press to disarm the system

G. ZOne SettinGS

Programming each zone in ARM mode:

Keys Description Note

(1234 or 4-digit

PIN) +

You must be in STANDBY

mode before turning to

ARM mode

*To make sure you are in STANDBY mode:

- Enter the default PIN “ 1–2–3–4 ” OR your new 4-digit PIN

- Press

- The panel will display the below image while you are in

STANDBY mode:

(One beep indicates that you entered a valid PIN, three beeps

indicate that an invalid operation was performed).

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Komentarze do niniejszej Instrukcji

Brak uwag

Mace MAS-WA-SYS Podręcznik Użytkownika Strona 12

Komentarze do niniejszej Instrukcji